Brake Pads Bedding Procedure

You dont need to come to a complete.

Brake pads bedding procedure. If you follow the brake pad bed-in procedure your rotors will be completely bedded. Step 1 Remove the rotor of each wheel that will receive new ceramic brake pads during installation. Perform 3-4 medium stops from 45mph.

The recommended procedures below should provide you with the information you need to select the bed-in procedure appropriate for your application. Gradually increase the speed and the braking until the pads. Leave at least 1km between each brake.

There should be an even smooth pad transfer layer on the disk. Following the bed-in procedures provided by the manufacturer will assure a smooth even layer of transfer film on the rotor and will minimize brake. Drive vehicle to 60km and evenly apply pressure to the brakes for a 3 second duration slowing the vehicle down to around 10km.

This will allow for less brake squeal less vibration and improved performance. Because of this treatment PBS brake pads only need light bedding in to match the padding to the disc. Drive at approx.

It is very important that this initial layer of. After bedding in but you still have squeaking. This process will lay down a thin layer of transfer film on to the rotor surface.

Bedding in of brake pads is a process that usually takes between 300-500 miles depending on the type of driving you do but following the recommended procedure directly after installation is of utmost importance. This process removes unwanted gasses from the materials in advance reducing the gasses that can cause fade within the brake pad. Type-D v20 Bed-In Procedure.