Bed Pid
I recently flashed the tinymachines firmware on my E5 just to get the bed PID tuning function and other nice features was kinda tricky getting a good guide and the correct files but I managed to get it working.
Bed pid. Some firmwares have a setting to enable PWM for the bed as well. PID needs to have a P I and D value defined to control the nozzle temperature. Its almost a completely different machine now.
However without a consistent temperature prints can fail to adhere to the bed. Set the temperature of hotend to 200C. When you run the command tuning begins.
PID autotune for the bed. Calibrating your heat bed with PID Tuning should be even easier now that you. Here it would be 0 for the hotend and 1 for the bed.
Simple and timeless this bed is versatile enough to complement any and all interior. Is this issue still resolved. Potentially solved I did two things.
If your shares are sponsored by the share registry ie. The autotune of the bed will fails. But an important one.
After you get the calibrated values you will enter and save them in your firmware so you dont have to run PID Tuning again. As the temperature fluctuates the. To calibrate a heat bed with PID Tuning you will need to run an M303 command in the G-code terminal of a software like Pronterface or OctoPrint so it goes into your printers firmware.

