Anet A8 Bed Temp Wrong

Make sure that the jumper that chooses between the power coming from the usb or from the power supply is located correctly.

Anet a8 bed temp wrong. If step 1 2 both show. To achieve higher temperatures a few changes are needed. It wasnt so much.

I ordered replacement parts but it will take 3-4 weeks to arrive. There will be heat developing. For Anet A8 Plus and many other desktop FDM 3D printers with a heat bed printing temperatures usually include hot end nozzle temperature and bed temperature.

Thanks to GearBest my order of spare main boards was delayed until a few days ago and my printer is normally on the go so I didnt want to strip it down. But these connectors are not designed to constantly moving aroud so a strain reliefsee below could probably solve the problem. Unplug everything but the main power.

But now every print I put through it starts with the Z being way to high everything states that it needs to be off set but how. So theoretically the connector is just enough. Define WATCH_BED_TEMP_PERIOD 60 Seconds define WATCH_BED_TEMP_INCREASE 2 Degrees Celsius endif This describes that the software waits for 60 seconds for the bed to increase 2 C.

Change wires of E_T and B_T port and click Reset. Set temp for bed do not wait M190 Sbed0_temperature. Thingiverse Groups Anet A8 Prusa i3 General Heat bed not heating showing wrong values.

My issue here is that it refuses to print anything centered. Hi Im a proud Anet A8 owner and of course the hotbed connector fried So far everythings normal D More seriously I screwed up my soldering and now the thermistor is dead. Hot end or nozzle temperature setting varies in accordance with the printing filament.